Errors
There are several errors and warnings that the unit tracks. When one of these errors occurs, the unit will save to its internal memory that this error has occurred since the errors were last reset. These errors are viewable in the configuration tool:
These errors persist even when the unit is power cycled, seeing an error present in the configuration tool is an indication that the error occurred since the errors were last reset and not necessarily that it happened the last time the unit was powered.
The possible errors are listed below:
Error | Description |
|---|---|
Corrupt Configuration | Configuration of onboard unit settings is corrupt. Potential firmware update occurred, or hardware fault. |
Bridge Fault | Output 3 phase bridge test failed due to hardware fault. |
Unit Max Voltage Exceeded | The maximum voltage for the unit was exceeded, triggering an over-voltage response. |
Configured Max Voltage Exceeded | The configured maximum voltage on the unit was exceeded. |
Configured Min Voltage Exceeded | The configured minimum voltage on the unit was exceeded. |
Signal Input Lost | The signal input was lost during operation. |
Bootloader Error | The bootloader is reporting an error within either firmware or recovery section. |
Absolute Over-temperature Occurred | The system entered an error state because the ESC temperature exceeded the maximum hardware limit. |
Firmware Error Active | The system encountered an invalid device configuration or generated a hard-error. |
Watchdog Reset Occurred | A software crash was detected, causing unit to restart. |
Firmware Low Memory Warning | The system encountered a low memory situation. |
Flash Corrupted | The errors saved to the device were cleared due to corruption or a firmware update. |
Configuration Invalid | An invalid configuration was saved onto the unit and the unit entered an error state. |
Motor Temperature Sensor Error | The motor temperature sensor reported erroneous values. |