Status Beeps

the following beep tones are present during unit operation as an extra form of diagnostics parallel to the status led beeps will only sound if a motor is connected and there is sufficient voltage to drive beeps can be disabled through unit configuration beep groupings can be disabled individually name beep pattern grouping meaning initialisation beep 2 tones ‘high low ’ status beeps the unit has successfully powered on signal searching beep 1 tone status beeps the unit is operating normally and has not yet acquired a signal this beep repeats every 2 seconds from the idle state signal acquisition beep 3 tones ‘low medium high ’ warning beeps the unit has acquired or re acquired a signal and may begin driving disarming beep 3 tones ‘high high low ’ warning beeps the unit has disarmed from the armed state a non zero throttle signal will no longer cause the motor to drive arming beep 3 tones ‘low low high ’ warning beeps the unit has armed from the disarmed state a non zero throttle signal will cause the motor to drive motor starting beep 2 tones repeating ‘high low ’ motor starting beep the motor will start spinning once the beep concludes identify beep 6 tones repeating ‘3 high 3 low ’ used to identify which esc is being configured by the configuration tool