Status LED

the status led on each unit will illuminate with different colours and patterns to indicate the current operating state of the unit the led mode setting can be used to determine which led patterns are visible when the led mode is set to stealth mode, certain patterns will not be shown as described in the table stealth mode details can be found below below are the explanations and descriptions of the colour states led colour description enabled in stealth mode blinking red a hard error has occurred, and the motor drive is disabled connect to the configuration tool or check telemetry flags on solid orange communications only mode is active the unit can be connected to the configuration tool motor drive is disabled and data logging is paused this mode can only be exited when using the configuration tool or by restarting the device when started up under usb power only the esc will enter this mode automatically on blinking purple the unit is in idle state, the unit is waiting for a signal no protocols are detected on blinking green motor control is active, and esc is armed and actively driving the motor off blinking aqua esc is armed and waiting for a non zero signal to begin driving the motor off blinking yellow esc is disarmed and waiting for arming conditions to be met this check can be bypassed depending on configuration and protocol on fast blinking pink esc is about to restart on fast blinking white esc is blinking to identify itself on solid red a critical error has occurred within firmware and recovery contact us for more information on